Unique FW Belt Applied For High Temperature Environment

FW Belt is usually applied in the washing tunnel due to its high loading capacity and porosity. The most widely is for cleaning the beverage can. However, one of our clients applied FW Belt for high temperature environment. Before contacting with KTK, this client purchased from another local supplier, but the mesh belt appeared the phenomenon of skipping teeth.

Here are some common reasons for skipping teeth.

1. The most common is that the pitch of FW Belt is uneven, which means that the mesh belt and the sprocket are not matched.

2. FW Belt is deformed during the operation under high temperature environment, which causes the mesh belt will not match the sprocket.

3. The two sprockets are misaligned, which is uncommon.

How to avoid skipping teeth?

Firstly, check the sprockets for alignment errors.

Secondly, adjust the flatness of the mesh belt, and check whether the mesh belt is deformed.

Finally, check the pitch of the mesh belt. This is where other local suppliers' mesh belts are most likely to have problems.

What's the advantage of KTK's FW Belt?

Currently, other local suppliers produce FW Belt by manual bending, which cannot ensure the pitch and bending angle of mesh belts accurately.

KTK has unique automated machine to press the wire, which can ensure the consistency of opening, to guarantee the flatness of FW Belt. At the same time, KTK always adhere to the quality policy that defective products cannot leave from the factory. To ensure that the products received by every customer are of high quality, so that customers do not have unnecessary repairs, which is what KTK have been working for.